Usrobotics V.34 Manuel d'utilisateur télécharger pdf (Page 153)

COURIER HIGH SPEED MODEMS

Remote Access D-11

To assign a password that allows viewing privileges only, use

the command format below:

AT%P0=[password] <Enter>

To assign a password that allows viewing and configuration

privileges, use the command format below:

AT%P1=[password] <Enter>

Disabling Password Security

If you want to disable an assigned password (and thereby dis-

able remote access security), use the following command

format:

AT%P0= <Enter>

AT%P1= <Enter>

WARNING: If you disable the %P1 password, a remote user

does not need to enter a password for configuration access.

Enable Remote Access

Set Register S41 for a value of 1 or greater. S41 is used to set the

number of allowable login attempts, as explained later. A

setting of zero allows no login attempts, and thus disables

remote access.

AT S41=1 <Enter>

NOTE: This method will not work if your modem is attached

to certain synchronous devices. Refer to Appendix F for more

information.

LED Indicator for Remote Access

The Courier's SYN status light indicator (LED) flashes to

indicate when it is in a remote access session.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 244 245

Pas de commentaire

Usrobotics V.34 Manuel d'utilisateur Page 153