USRobotics NETServer/16 Manuel d'utilisateur télécharger pdf (Page 199)

Command Reference 10-49

Routes Table Configuration

The routes table contains both static and dynamic routing

information. Dynamic routes are updated by RIP broadcasts

received from other routing devices on the network. Static

routes are routes added to the table by hand. A static route to a

given location will override any dynamic routes to the same

location. Static routes are required when dynamic routes to a

given location are not being received (For example, when RIP is

not running).

How to . . .

Bring Up the List of Commands

Use the following command for the IP Routes table:

help set route

Use the following command for the IPX Routes table:

help set ipxroute

Add a Route to the Routes Table

To add IP route, use the following command:

add route <destination> <gateway> <metric>

To add an IPX route, use the following command:

add ipxroute <destination> <gateway> <metric> <ticks>

Change a Route’s Information

To change a route’s entry in the Routes Table, you must delete

the old route and replace it with a new one.

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 283 284

Pas de commentaire

USRobotics NETServer/16 Manuel d'utilisateur Page 199