USRobotics NETServer/16 Manuel d'utilisateur télécharger pdf (Page 37)

Configuration Overview 3-7

Initialization Script Configuration

A Port Initialization Script is a string of text that is sent to a

modem (or S0, the external serial port) each time the port is

reset (a modem resets itself every time it disconnects).

Initialization scripts for the modems will probably contain the

AT commands needed to configure them for use on your

network.

Location Table

The location table stores information about remote sites that the

NETServer needs to dial out to. The table is used during LAN-

to-LAN routing, to tell the NETServer how to dial out to and

communicate with a remote location. It is also used for dialing

back network dial in users. Each location is configured with

parameters such as what addresses and which protocol to use

for the connection. A dial script for each location contains

instructions on how to dial out to and sometimes even how to

log into a remote host.

Net0 (LAN Port) Configuration

The Net0 Port Configuration table configures the LAN Interface.

These settings reflect how the LAN attached to the NETServer is

configured and include, for example, what protocol the LAN is

using (IP, IPX, or both).

Netmasks Table

The netmasks table is used when you want to employ Classless

InterDomain routing (also called Supernetting). Supernetting is

a specialized IP addressing technique used by some Internet

service providers. The technique requires that special netmasks

be defined using the netmasks table.

See Appendix B For more information on supernetting.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 283 284

Pas de commentaire

USRobotics NETServer/16 Manuel d'utilisateur Page 37